Sanyo 85464359982001 installation instructions Routing the Tubing, Fig

07-007 W-2WAY_II_NA 1/23/07 6:09 PM Page 56

4-3. Routing the Tubing

●The tubing can be routed out either from the front or from the bottom. (Fig. 4-6)

●The connecting valve is contained inside the unit. Therefore, remove the front panel. (Fig. 4-6)

(1)If the tubing is routed out from the front, use cutting pliers or a similar tool to cut out the tubing outlet slit (part indicated

by ) from the tubing cover. (Figs. 4-5 and 4-6)

Front

Bottom	Remove 11 panel
	screws from front
	panel

Tubing cover
Remove 2 screws	Use cutting pliers or similar
	tool to cut cover out

Fig. 4-5

(2)If the tubing is routed out from the bottom, remove the

slit part ( ).

●Use a drill bit approximately 13/64 dia. to create holes at

the 4 slit hole indentations (openings).

●Punch out the slit part ( ).

●Be careful not to damage the base plate.

Indentation (4 locations)

Slit hole

Fig. 4-6

56