Sanyo 85464359982001 Suspension bolts referring to the dimensional data on, Necessary

07-007 W-2WAY_II_NA 1/23/07 6:09 PM Page 40

3-15. Suspending the Indoor Unit

Depending on the ceiling type:

•Insert suspension bolts as shown in Fig. 3-63 or

•Use existing ceiling supports or construct a suitable support as shown in Fig. 3-64.

Hole-in-anchor
Hole-in-plug	Concrete	Insert

Suspension bolt (M10 or 3/8") (field supply)

WARNING

U

It is important that you use extreme care in supporting the indoor unit inside the ceiling. Ensure that the ceiling is strong enough to support the weight of the unit. Before hanging the unit, test the strength of each attached suspension bolt.

Fig. 3-63

Ceiling tiles

Ceiling support

(1)	When placing the unit inside the ceiling, determine the pitch of
	the suspension bolts referring to the dimensional data on the
	previous page. (Fig. 3-61 and Table 3-3)
	Tubing must be laid and connected inside the ceiling when
	suspending the unit. If the ceiling is already constructed, lay the
	tubing into position for connection to the unit before placing the
	unit inside the ceiling.
(2)	Screw in the suspension bolts allowing them to protrude from
	the ceiling as shown in Fig. 3-63. (Cut the ceiling material, if
	necessary.)
(3)	Thread the 3 hexagonal nuts and 2 washers (field supply) onto
	each of the 4 suspension bolts as shown in Figs. 3-65 and 3-66.
	Use 1 nut and 1 washer for the upper part, and 2 nuts and 1
	washer for the lower part, so that the unit will not fall off the

	Fig. 3-64
		Suspension bolt
Nuts and washers			Suspension lug
(use for upper and lower)

suspension lugs.

Double nuts

Notch

Fig. 3-65

		Suspension bolt
		Hexagonal nut
● Fig. 3-67 shows an example of installation.		Double nuts
		Bolt anchor
Air outlet duct		Fig. 3-66
		Suspension bolt
		Air-intake duct
Air-outlet grille
Ceiling material	Indoor unit

Air-intake grille

Fig. 3-67

40