SATO DR300 manual Stop Position Adjustment

DR300 Operator Manual Chapter 4 - Setting of Label and Carbon Ribbon

•Close Cover.

Stop Position Adjustment

The correct stop position for dispense mode is the position where label is 2-3mm on backing paper. Adjust OFFSET (VR) to obtain correct stop position.

•There may be cases when the dispenser does not function properly due to the thickness of the labels used.

•Printing accuracy at peeling is V (Vertical) direction ± 1.5 mm, label size direction ± 1.0mm.

•Dispenser unit is effective for label pitch 25-181mm. However, label size limitation may vary with application conditions.

•Labels over 100mm may curl at dispense due to the nature of the material. There is no remedy for this.

20