DR300 Operator Manual | Chapter 5 - Power Supply |
|
|
Print image shifts from its position
|
| Check Point |
|
| Remedy |
1. | Are the labels and carbon ribbons | Check if labels and carbon ribbons are | |||
| properly set? |
|
| fixed firmly and at the correct position by | |
|
|
|
|
| lifting head assembly. |
2. | Is the platen roller dirty? |
|
| Clean dirt off from platen roller with | |
|
|
|
|
| cleaning kit. |
3. | Are deformed labels or carbon | Use genuine SATO new labels and carbon | |||
| ribbons being used? |
|
| ribbons which are in good condition. | |
4. | Are genuine labels and carbon | Genuine labels and carbon ribbons | |||
| ribbons | exclusively | for | this | exclusively for this equipment must be |
| equipment being used? |
|
| used. | |
|
|
|
|
| Available from SATO. |
5. | Is the content of data or signal from | ||||
| the computer correct? |
|
| If similar message is displayed, check | |
|
|
|
|
| content of software and communication |
|
|
|
|
| settings at the computer side. |
6. | Is the print position offset setting | Adjust the print position offset. | |||
| correct? |
|
|
|
|
•Disconnect printer from mains before cleaning.
29
