Savin 3360DNP operating instructions Designated area Area recognized Preferred designated area

Operation

•There is no limit to the number of areas you can designate on a single com- mand sheet.

1

•If designated areas on two or more command sheets overlap, the last com- mand sheet will apply to the overlapping portion.

•If you use Outline mode for letter images with a thickness of less than 3mm, 0.12", the print image might come out as expected.

-Notes

The image might differ depending on how the designated area is drawn, so re- member the following when making the command sheet.

Designated area	Area recognized	Preferred designated area
Part of the designated area is		Make a space of at least 2mm,
surrounded by 3 sides of the en-		0.08", in front of the area surround-
tire area.		ed by 3 sides (relative to the feed
		direction).
		1	2

		1, 2 = 2mm, 0.08"
Double line pattern.	Only the outer line is	Make a gap of at least 2mm, 0.08"
	recognized.	in width.

88