Savin 3360DNP operating instructions 147

		User Tools Menu
No.	Mode	Description
15	Deflector Angle	You can change the angle of the wing guide depending on the pa-
		per type you use.
		Note
		❒ Default: Auto
		❒ Available settings:
		• Up (Select this setting when standard thickness or thin pa-
		per misfeeds at the paper exit section occur frequently.)
		• Down (Select this setting when A4 – B5, 81/2" ⋅ 11" thick
		paper is not delivered properly to the paper delivery tray.)
16	Auto Class	When you do not use the Separation mode, you can select the ma-
		chine's condition after each printing set is fed out to the paper de-
		livery tray.
		Note
		❒ Default: Stop
		❒ Available settings:
		• Start printing automatically (After the last page of each
		printing set is fed out to the paper delivery tray, the ma-
		chine stops for a few seconds. Then, the next cycle begins.)
		• Stop (After the last page of each printing set is fed out to
		the paper delivery tray, the machine stops. If you press the
		{Print} key, the next cycle begins.)
17	Auto Separate	Specifies whether Job Separation mode is automatically carried
		out when you make prints in All Class, Auto Class, Manual Class,
		or Class mode.
		Note
		❒ Default: ON
18	Ink/Master Left	Specifies whether you can check the amount of ink and master.
		Note
		❒ Default: OFF
		❒ Available settings:
		• OFF (You cannot check the remaining amount of ink or
		master.)
		• ON (When the remaining amount of ink or master is less
		than half, the panel display indicates these amounts when
		you turn on the main switch.)
		• Check remaining volume (You can see the remaining
		amounts of ink and master regardless of these amounts.)
19	Type of Paper	When one kind of paper misfeed occur frequently, you can regis-
		ter its paper type in “User1” or “User2”.
		Reference
		For registering a special paper type, see p.158 “4-19 Type of
		Paper”.

4

147