First steps

¤Insert the batteries the right way round (see figure).

The polarity is indicated in/on the battery compartment.

The handset switches on automatically. You will hear a confirmation tone.

Closing the battery cover

¤First, align the notches on the side of the battery cover with the protrusions on the inside of the housing.

¤Then press the cover until it clicks into place.

Opening the battery cover

¤If fitted, remove the belt clip.

¤Place your finger in the headset socket cavity and pull the battery cover upwards.

Connecting the charging cradle

Connecting the charging cradle and mounting it on the wall (if required) is described at the end of this user guide.

¤To charge the batteries, leave the hand- set in the charging cradle.

Please note:

–Only place the handset in the charging cra- dle that is intended for it.

–If the handset has switched itself off because the batteries are flat and if it is then placed in the charging cradle, it will switch itself on automatically.

For questions and problems see page 94.

8