Siemens S7-400 installation manual Wiring the Front Connector, Crimping

Wiring the S7-400

4.14Wiring the Front Connector, Crimping

Procedure

To wire the prepared front connector:

1.Strip the conductors at a length of approx. 5 mm.

2.Crimp the contacts onto the conductors. A crimptool is aailable on order as an accessory for your signal modules.

3.Insert the crimp contacts into the recesses of the front connector, starting at the bottom.

The order number for crimp contacts is found in Appendix C of the Reference Manual.

Figure 4-13 Wiring a Front Connector with Crimp Terminals

4-24	Automation System S7-400	Hardware and Installation
		A5E00850741-01