Wiring the S7-400

4.18Labeling a Front Connector

Labels and Terminal Diagram

Each signal module is provided with three labels: two blank labels and one printed label showing the terminal diagram for inputs and outputs.

Figure 4-18 shows the locations for fitting the individual labels on the front

connector.

 

Label

Terminal diagram

in front connector

interior

 

Label

 

exterior

Figure 4-18 Fitting the Labels on the Front Connector

To label a front connector, follow the steps outlined below:

1.Enter the addresses of the individual channels on the two labels. Note the slot numbers on the labels to record the assignment of front connector to module.

2.Place a label on the left of the opened front connector. The label has a T-shaped blank in the middle with which you can fix the label onto the front connector housing. Bend the blank slightly to one side and push it behind the corresponding cutout of the front connector whilst sliding in the label

(see Figure 4-19).

3.Refit the cover on the front connector.

4.Slide the label with the terminal diagram of the inputs or outputs into the interior of the cover of the front connector.

5.Slide a label externally into the cover of the front connector.

Automation System S7-400

Hardware and Installation

4-29

A5E00850741-01

 

Page 89
Image 89
Siemens S7-400 installation manual Labeling a Front Connector, Labels and Terminal Diagram