gTo connectyour interactive flatpanel to power and computer 1
1. Connect the includedVGA cablefrom computer 1 to the VGA 1 receptacle on the bottom
terminalpanel.
2. Connect the includedU SB cable from theU SB 1 receptacle on the inside terminalpanel of the
interactiveflat panelto a USB receptacleon the computer.
3. Connect the includedpower cable from the AC IN c onnectoron the bottom terminalpanel to a
poweroutlet.
4. Connect the power cablefrom your computer to a poweroutlet.
5. Turn ony ourcomputer.
6. Turn ont hemain power switch on the bottom terminal panel,and then press the Power button
onthe front control panel.
7. Press the VGA 1 buttonon the remote control.
OR
Press the Input button onthe front control paneluntil t heinput source is VGA1.
Installing computer 2 connection
Youcan install c ablingthat enables you to connect a second computerto your interactive flat panel
fromanother location in theroom, such as on a conference table. By installing this connection, you
makeuse of connection pointsthat might not beaccessible when yourinteractive flat panelis
wall-mounted.
Yourequire a USB cable anda V GA cablet o install the computer2 connection. You may install these
cablesand run them throughfloors or walls to a nearby table.
Alternatively, yourusers can connect a laptop to the side terminalpanel using the moreacc essible
USB receptacleand HDMI input. Formore information,s eeC onnectinga guest laptop on page47.
Fora diagram of the variousc omputeroptions, see Connecting computersto y ourinteractive flat
panelon page 16.
WARNING
Ensurethat any cables extending across the floor to yourSMAR T productare properlybundled and
markedto avoid a trip hazard.
NO T E
Youdo not requirea laptop to install this cabling.
CH A P T E R 3
Connectingcomputers and peripheral devices
18