SMC Networks SMC7816M, SMC7816VSW T, G, 9-13, Configuring LACP Parameters

C REATING T RUNK G ROUPS
9-13
CLI – The following example enables LACP for ports 1 to 6. Just connect
these ports to LACP-enabled trunk ports on another switch to form a
trunk.
Configuring LACP Parameters
Dynamically Creating a Port Channel –
Ports assigned to a common port channel must meet the following criteria:
• Ports must have the same LACP System Priority.
• Ports must have the same LACP port Admin Key.
• However, if the “port channel” Admin Key is set (page 4-142), then the
port Admin Key must be set to the same value for a port to be allowed
to join a channel group.
Console(config)#interface ethernet 1/1 25-2
Console(config-if)#lacp 26-4
Console(config-if)#exit
.
.
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1 25-13
Information of Trunk 1
Basic information:
Port type: 100TX
Mac address: 00-30-F1-D4-73-A2
Configuration:
Port admin: Up
Speed-duplex: 100full
Capabilities: 100full
Flow control: Disabled
Port security: Disabled
Max MAC count: 0
Current status:
Created by: LACP
Link status: Up
Port operation status: Up
Operation speed-duplex: 100full
Flow control type: None
Member Ports: Eth1/1, Eth1/2, Eth1/3, Eth1/4, Eth1/5, Eth1/6,
Console#