SMC Networks SMC7816M, SMC7816VSW VDSL I, 29-71, show lre tone

D ISPLAYING VDSL I NFORMATION
29-71
transceiver will automatically control upstream power backoff based
on default values set by the DSP engine.
Example
This example shows that UPBO has been enabled on Port 1.
Related Commands
lre upbo (29-19)
show lre tone
This command shows if VDSL signals are enabled or disabled at
frequencies less than or equal to 640 KHz, 1.1 MHz or 2.2 MHz.
Syntax
show lre tone [unit/port]
•unit - Stack unit. (Range: 1)
•port - Port number. (Range: 1-16)
Command Mode
Privileged Exec
Command Usage
Use this command without the interface parameter to show if VDSL
signals are disabled at low-end frequencies for all VDSL ports on the
switch, or with an interface to display this information for a specific
port.
Example
This example shows the default setting for disabled low-end frequencies.
Console#sh lre upbo 1/1
UPBO status : Enable
Console#
Console#show lre tone 1/1
RX Bandplan Configuration : Disable tones 1.1 MHz and below
TX Bandplan Configuration : Disable tones 1.1 MHz and below
Console#