D
ISPLAYING
VDSL I
NFORMATION
29-61Displaying VDSL Information

This section describes the commands used to display information on

VDSL configuration settings, signal status, and communication statistics.

Table 29-9 Commands for Displaying VDSL Information

Command Function Mode Page
Displaying Configuration Settings
show lre band-plan Displays the frequency bands used for
VDSL signals
PE 29-62
show lre
option-band
Displays the frequencies to be used for the
optional US0 band
PE 29-63
show lre ham-band Displays the HAM radio band that is
blocked to VDSL signals based on defined
frequencies
PE 29-64
show lre
region-ham-band
Displays the HAM radio band that is
blocked to VDSL signals based on defined
usage types
PE 29-65
show lre psd Displays the power level set for each of the
PSD breakpoints
PE 29-67
show lre
psd-mask-level
Displays the predefined PSD mask
configured for an interface
PE 29-68
show lre pbo-config Displays the mask used to reduce the power
spectral density (PSD) of transmitted signals
at specified frequency breakpoints
PE 29-69
show lre upbo Shows if upstream power backoff is enabled
or disabled
PE 29-70
show lre tone Shows if VDSL signals are enabled or
disabled at frequencies less than or equal to
640 KHz, 1.1 MHz or 2.2 MHz
PE 29-71
show lre
interleave-max-delay
Displays the maximum interleave-delay for
downstream and upstream channels
PE 29-72
show lre datarate Displays the minimum and maximum data
rate for
downstream and upstream fast or
slow (interleaved) channels
PE 29-73