The current shutter setting appears for about 3 seconds in the setting change and adjustment progress message display area of the viewfinder screen.

E.g.: SS : 1/250 or : CLS : 60.6 Hz

3 Before the message from step 2 disappears, push the SHUTTER selector to SEL again and repeat until the desired mode or speed appears.

4 Pushing the SHUTTER selector to SEL repeatedly allows you to cycle through the settings of mode and speed preselected on the SHUTTER SPEED page of the setup menu.

Note that all modes and all standard-mode speeds listed in the table on page 4-12 are preselected using the SHUTTER SPEED page of the setup menu.

For more information about the SHUTTER SPEED page, see “Changing the

range of choice of shutter mode and speed settings” (page 4-17).

Standard mode

1/100 (or 1/60)1/125 1/250 1/500 1/1000 1/2000

 

CLS/ECS m

ode a)

EVS mode

 

a)Either CLS mode or ECS mode (DNW-90/90P/90WS/90WSP only) is selected depending on the shutter speed set in the setup menu CLEAR SCAN page.

Selectable settings of shutter mode and speed (factory setting)

Once a shutter speed is selected, it is maintained until the next shutter speed setting operation.

When the message “STORED DATA:NG” appears, the shutter speed returns to 1/100 s (DNW-7/90/90WS/9WS) or 1/60 s (DNW-7P/90P/ 90WSP/9WSP).

4-14Chapter 4 Adjustments and Settings for Recording