2Audio signal input/output section

1INPUT LEVEL selector

2 AUDIO IN jacks

3 AUDIO OUT

 

connectors

Overview 1 Chapter

1INPUT LEVEL (–10/–2/+4) selector Selects one from among –10 dB, –2 dB, or +4 dB

according to the audio level of the signal input via the AUDIO IN jacks 2.

Note

If this selector setting is not appropriate, clipping distortion or noise may occur even if the AUDIO INPUT switch has been set to AUTO.

For more information on the setting of this selector, see “When you set the INPUT LEVEL selector” on page 96 (GB).

2AUDIO IN CH-1 to CH-4 jacks (phono jack) Inputs audio signals (CH-1 to CH-4).

Note

To input balanced audio signals via these jacks, use a conversion cable as shown below. (The COLD side is open.)

For details on conversion cables, refer to the instruction manual of the devices you use.

GND

HOT

COLD ⋅

3AUDIO OUT CH-1 to CH-4 connectors (XLR 3- pin, male)

Outputs audio signals (CH-1 to CH-4).

Chapter 1 Overview

23 (GB)