This section describes the connections, settings and operations necessary to perform playback on this unit. The same settings and operations apply whether you are using the unit as part of an editing system, for dubbing, or as a
To digital video equipment with a DV jack
The video and audio signals are sent with hardly any degradation, enabling
Monitor
i.LINK cable (DV cable) (not supplied)
DV jack
Digital video
equipment with a Monitor DV jack
: Signal flow
Notes
•With the DV connection, data codes (recording date/ time, camera data) recorded on the source tape are transmitted to the recorder. As a result, when you play back a recorded tape on this unit and press the DATA CODE button on the Remote Commander, the same data codes as those recorded on the source tape are displayed on the monitor screen.
•The external lock function of this unit only supports the standard sync signals. With the DV connection, set EXT SYNC on the VIDEO SET menu to OFF to prevent malfunction resulting from noise, etc.
For details on the VIDEO SET menu, see “VIDEO SET menu” on page 86 (GB).
•If no picture appears via the DV jack, disconnect the i.LINK cable (DV cable), then reinsert it straight.
•When connecting a device that has a
•If the unit is connected to a device equipped with a 6- pin DV jack, when you intend to disconnect or reconnect the DV cable, turn off the device and pull out the plug of its power cord from the AC outlet beforehand. If you connect or disconnect the DV cable while the device is connected to the AC outlet,
•If you connect the input connectors of this unit to the output connectors of a recorder or that of a monitor, a humming noise may be generated or the image may be distorted. If these phenomena occur, perform one of the following:
–Set DV EE OUT on the VTR SET menu to OFF.
–Set the INPUT SELECT selector to a position where a signal is not currently being input.
–Disconnect the cables.
Recording and Playback 2 Chapter
Chapter 2 Playback and Recording | 33 (GB) |