3 Set the F-RUN/SET/R-RUN switch to SET.

4 If you are using the DVW-707/709WS/790WS, set the DF/NDF switch. (NTSC only)

DF: Drop frame mode

NDF: Non-drop frame mode

5 Using the SHIFT and ADVANCE buttons, set the time code. SHIFT: Selects a digit to set. Each time you press it, the flashing

4 column moves to the right one digit.

Pressing this button while holding down the HOLD button moves the flashing digit one to the left.

ADVANCE: Increments the flashing digit.

Pressing this button while holding down the HOLD button decrements the flashing digit.

6 Set the F-RUN/SET/R-RUN switch to F-RUN or R-RUN. F-RUN:Free run - The time code advances constantly.

R-RUN:Record run - The time code stops except during recording.

Notes

•The time code continues to advance when Loop Rec mode is turned on, even when the system is set to REC-RUN mode.

•When you turn on the Loop Rec function, make sure either the mode is set to F-RUN or R-RUN after setting the time code. If you begin recording with the switch in SET position, the time code will not be recorded correctly.

The Loop Rec function is provided by the optional BKDW-703 extension board. For more details, see Section 3-2-3 “Starting a Shot with a Few Seconds of Pre-Stored Picture Data (Loop Rec Function)(When Using a BKDW-703 Extension Board) ”(page 3-12)

4-30Chapter 4 Adjustments and Settings for Recording