OPERATION PANEL (ADMINISTRATOR)
Network SettingsNetwork settings are described below. Select the [Network Settings] key to configure the settings.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine see "TURNING THE POWER ON AND OFF" (page
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine. The settings are shown below.
IP Address
Enter the IP address of the machine.
IP Subnet Mask
Enter the IP Subnet Mask.
IP Gateway
Enter the IP Gateway address.
DHCP
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol). When this setting is enabled, it is not necessary to manually enter an IP address.
• If the machine will be used on a TCP/IP network, be sure to enable "Enable TCP/IP" below.
•If DHCP is used, the IP address assigned to the machine may change automatically. If the IP address changes, specify the printer port setting again and then print.
• If the machine will be used on a TCP/IP network, be sure to enable "Enable TCP/IP" below.
•If DHCP is used, the IP address assigned to the machine may change automatically. If the IP address changes, specify the printer port setting again and then print.
•In an IPv6 environment, the machine can use LPD or IPP protocol.
Enable TCP/IP
To use the machine on a TCP/IP network, this setting must be enabled.
Enable NetWare
To use the machine on a NetWare network, this setting must be enabled.
Enable EtherTalk
To use the machine on an EtherTalk network, this setting must be enabled.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network, use this setting to configure the IP address of the machine. The settings are shown below.
Enable IPv6 Protocol
Enable this setting.
DHCPv6
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol). When this setting is enabled, it is not necessary to manually enter an IP address.
Manual Address
Enter the IP address of the machine.
Prefix Length
Enter the prefix length (0 to 128).
Default Gateway
Enter the IP Gateway address.
Enable NetBEUI
To use the machine on a NetBEUI network, this setting must be enabled.
Reset the NIC
This returns all "Network Settings" to the factory default settings.
Ping Command
Use this function to check if the machine can communicate with a computer on the network. Specify the IP address of the desired computer and select the [Execute] key.