WEB PAGE (ADMINISTRATOR)
Device Control
These settings control devices installed on the machine. Select [System Settings] - [Device Control] from the menu bar and configure each setting.
Disabling of Duplex
This is used to disable
Disabling of Optional Paper Feed Unit
(When a
This setting is used to disable a
Auto Paper Selection Setting
The paper types* that the Auto Paper Selection function will select can be specified. Select one of the following settings:
•Plain Paper
•Plain and Recycle Paper
•Recycle Paper
The Auto Paper Selection function will not select any paper types other than the paper types specified with this setting.
*The paper type set for each paper tray using "Paper Tray Settings" (page
Disabling of Tray Settings
This setting is used to prohibit tray settings (except for the bypass tray).
Disabling of Offset
(When a finisher is installed.)
This setting is used to disable the offset function.
Disabling of Stapler
(When a finisher is installed.)
This setting is used to prohibit stapling, such as when the stapler unit of the finisher malfunctions.
Fusing Control Settings
These are used to control the toner fusing temperature according to the weight of the paper.
These settings apply to plain paper, recycled paper, punched paper,
You can select "16 to 23 lbs." or "23+ to 28 lbs." ("60 g/m2 to 89 g/m2" or "90 g/m2 to 105 g/m2").
• Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix plain or other paper that is outside the range with the paper in the tray.
•When settings are changed, the changes will take effect after the machine is restarted. To restart the machine see "TURNING THE POWER ON AND OFF" (page