IMPORTANT POINTS WHEN USING THE BYPASS TRAY

•When using plain paper other than SHARP standard paper or special media other than SHARP-recommended transparency film, or when printing on the reverse side of previously used paper, the paper must be loaded one sheet at a time. Loading more than one sheet at a time will cause misfeeds.

•Before loading paper, straighten any curling in the paper. If curled paper is not straightened, a misfeed may occur.

•When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and reload as a single stack. If paper is added without removing the remaining paper, a misfeed may result.

Inserting paper

Place paper in the horizontal orientation.

Inserting transparency film

•Use SHARP-recommended transparency film. When using transparency film, place the film on the bypass tray with the rounded

corner at the left front. This ensures that the print side faces in the correct direction.

• Do not touch the print side of transparency film.

• When loading multiple sheets of transparency film in the bypass tray, be sure to fan the sheets several times before loading.

•When printing on transparency film, be sure to remove each sheet as it exits the machine. Allowing sheets to stack in the output tray may result in curling.

1-43