Star Micronics HL 80825321 user manual Loading fanfold paper

Rear cover
Capot arrière
Traktorabdeckung	Release lever
Coperchio posteriore
	Levier de dégagement
	Papierwahlschalter
	Leva di rilascio

Cut-sheet

Feuilles séparées

Einzelblätter

Carta in fogli

Fanfold Papier continu Endlospapier

Carta in modulo continuo

Loading fanfold paper

This section tells you how to load fanfold paper. Note that you can also use cut-sheet paper and multi-paper form paper. For details on using other types of paper, see “Paper Handling” on page 111 of this manual.

❏Remove the paper guide from the printer.

❏Position the stack of paper behind the printer.

❏Make sure printer power is turned off.Set the release lever to the fanfold position.

❏Grasping the two back corners of the printer with the palms of your hands, press back on the two raised areas on the top of the rear cover until it opens.

❏Swing the rear cover back and down until it stops.

Note:

You can also completely remove the rear cover by simply pulling it away from the back of the printer after you open it.

❏Pass the fanfold paper through the space between the printer case and the rear cover.

❏Unlock the two tractor covers by pushing their gray levers down, and slide them so they are aligned approximately with the holes on the sides of the paper. Also move the center paper support so that it is approximately halfway between the two tractors.

15