Star Micronics HL 80825321 user manual Installing the platen knob, Opening the front cover

Platen knob

Molette du cylindre

Walzendrehknopf

Manopola del rullo

Front cover

Capot avant

Frontabdeckung

Coperchio anteriore

Tear assist edge

Barre de découpe

Papierabrißkante

Listello di separazione

Installing the platen knob

The platen knob is packed into a recess in the packaging material.

❏Install the knob on the shaft located inside the large hole on the right side of the printer. Make sure that the two splines of the platen shaft inside the printer fit into the slots inside the knob’s spindle. Press the knob carefully but firmly into place as far as it will go.

Opening the front cover

❏Lift up on the front cover while pressing in gently on its sides.

❏To close the front cover, simply lower it back into place.

Caution!

The tear assist edge is rather sharp. Take care to avoid injuring your hands.

Note:

You can completely remove the front cover from the printer or you can stand it up without removing it. You should normally leave the front cover closed, because it protects against objects getting into the printer, and it cuts down on printer noise.

5