Sun Microsystems CP3220 manual 2POST Options

4.On the Boot Settings Configuration screen (FIGURE B-17), you can enable or disable the options shown in TABLE 4-2

TABLE 4-2POST Options

Option	Description
Quick Boot	This option is disabled by default. If you enable Quick Boot, the BIOS skips certain tests
	while booting, such as the extensive memory test. This decreases the time it takes for the
	system to boot.
Quiet Boot	This option is disabled by default. If you enable this, the Sun Microsystems logo is
	displayed instead of POST codes.
AddOn ROM	This option is set to Force BIOS by default. This option has effect only if you have also
Display Mode	enabled the Quiet Boot option, but it controls whether output from the Option ROM is
	displayed. The two settings for this option are as follows:
	• Force BIOS – Remove the Sun logo and display Option ROM output.
	• Keep Current – Do not remove the Sun logo. The Option ROM output is not displayed.
Bootup Num-Lock	This option is On by default (keyboard Num-Lock is turned on during boot). If you set
	this to Off, the keyboard Num-Lock is not turned on during boot.
PS2 Mouse Support	This option is set to On by default. Select this option for PS/2 mouse support.
Wait for ‘F1’ If Error	This option is disabled by default. If you enable this option, the system will pause if an
	error is found during POST and will resume only when you press the F1 key.
Hit ‘F2” Message	This option is enabled by default. If you disable this option, the system will not display
	the “Press DEL to run Setup” messages in POST.
Interrupt 19 Capture	This option is reserved for future use. Do not change.
Show Extended	This option is disabled by default. If you enable this option, the systems shows the
System Information	extended system information at the end of POST and before the operating system takes
	control.

Chapter 4 Configuring and Using BIOS Firmware 4-15