▼Setting Configuration of OOS LED Behavior
Use the following command to set the configuration of OOS LED behavior.
Command |
| NetFn | Opcode | |
|
|
|
| |
Set IPMI Control Bits | 0xE9 | 0xE9 | ||
|
|
|
|
|
Data Bytes |
|
|
|
|
|
|
|
|
|
Type | Byte | Data Field |
|
|
|
|
|
|
|
Request Data | 1 | 00 |
|
|
| 2 | 00 |
|
|
| 3 | 2A |
|
|
| 4 | Control byte. |
|
|
|
| Bit 0 = LED 2 (Green LED) control bit: | ||
|
| • 1 = IPMC controls green LED. | ||
|
| • 0 = IPMC does not control green LED. | ||
|
| Bit 1 = LED1 (Amber/Red LED) control bit. | ||
|
| • 1 = IPMC controls LED1 for default behavior. | ||
|
| • 0 = IPMC does not control LED1. | ||
|
| Bits 2 to 7 = Reserved for future use. Write as 1s. (See | ||
|
| Note.) |
|
|
Response Data | 1 | Completion Code: |
|
|
|
| [00] OK |
|
|
|
| [C1] Command not supported | ||
|
| [CC] Invalid data in request | ||
|
| (Refer to IPMI specification for more completion | ||
|
| codes) |
|
|
| 2 | 00 |
|
|
| 3 | 00 |
|
|
| 4 | 2A |
|
|
|
|
|
|
|
Note – If an attempt is made to write 0 to any reserved bit (2 to 7), IPMC will reject the command with completion code 0xCC.
Chapter 3 Software Configuration |
