Sun Microsystems manual Service Procedures, Hot-Swapping the Sun Netra CP3220 Blade Server

2.3Service Procedures

2.3.1Hot-Swapping the Sun Netra CP3220 Blade Server

You can remove the Sun Netra CP3220 blade server without powering off the entire chassis by performing these steps.

1.Power off the blade server.

See Section 2.3.2, “Powering Off the Sun Netra CP3220 Blade Server” on page 2-17.

2.Remove the blade server.

See Section 2.3.3, “Removing the Sun Netra CP3220 Blade Server” on page 2-18.

2.3.2Powering Off the Sun Netra CP3220 Blade Server

1.Shut down the operating system.

Log in and shut down any OS operating on the blade server or its companion ARTM.

2.Deactivate the blade server.

Log in to the shelf manager and deactivate the blade server in the target slot.

For example, to shut down the blade server in slot 3, log in to the shelf manager and type:

#clia deactivate board 3

Wait for the blue Hot-Swap LED to light steadily before removing the blade server.

Chapter 2 Hardware Installation and Service 2-17