Sun Microsystems manual 10Sun Netra CP3220 Blade Server User’s Guide January

FIGURE 1-6Sun Netra CP3220 Blade Server, Backplane, and Relationship to ARTM

Sun Netra CP32x0 ARTM (installed from the rear)

Sun Netra CP3220 blade server (installed from the front)

ATCA backplane

Note – When using the Sun Netra CP32x0 ARTM with the Sun Netra CP3220 blade server, use shielded cables of less than 10 meters in length for serial I/O ports.

Caution – You must use shielded cables for all ports to satisfy EMI compliance standards.

You can order the CP32x0 ARTM, build a custom module, or buy one from an IHV. You must set up a minimal set of I/O for a boot path for the host board and for a path for console I/O to deliver commands and read board and system status.

Possible boot and console configurations are described in TABLE 1-1. Sun Microsystems provides the Sun Netra CP3220 blade server and optionally, a compatible Sun Netra CP32x0 ARTM. This module provides one

1-10Sun Netra CP3220 Blade Server User’s Guide • January 2010