Symmetricom XLi IEEE 1588 manual F131 BN F131 B4, Error Invalid Command

SSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSS

•Use the ENTER key to continue to the next screen.

•When prompted with “SAVE CHANGES? YES”, press the ENTER key.

To use F131, press the following keys on the front panel keypad:

ENTER 131 ENTER

The keypad display interface displays the following sequence of screens:

•PTP AVAILABILITY - OPTION BAY #

•READING PTP OPTION CARD - PLEASE WAIT 5 SECONDS

•PTP IP ADDRESS (STATIC)

-For PTP master, Option Bay 4 - 010.048.000.103

-For optional PTP slave, Option Bay 2 - 010.048.000.105

•PTP SUBNET MASK (STATIC) - 255.255.000.000 (Range:0 to 255 for each 3 digit address.)

•PTP DEFAULT GATEWAY (STATIC) - 010.024.000.001 (Range:0 to 255 for each 3-digit address.)

•PTP DHCP - ENABLE (or DISABLE or DHCP) (if enabled, the next three screens provide the IP Address, Subnet Mask, and Gateway assigned by the DHCP server.)

•PTP SYNC INTERVAL - 2 (or 1, 8, 16, 64)

•PTP BURST MODE - DISABLE (or ENABLE)

•PTP PORT STATE - ENABLE (or DISABLE)

•PTP SUBDOMAIN NAME - _DFLT (or _ALT1, _ALT2, _ALT3)

•PTP RESET TO FACTORY DFLT? - NO (or YES)

•PTP INIT TO USER SETTINGS? - NO (or YES)

•PTP CLOCK CONFIG, BAY 2 - MASTER (or SLAVE PRI, SLAVE SEC, SLAVE STBY)

•SLAVE SYNC THRESHOLD - 5 microsec (or 1000 microsec)1

•PTP PREFERRED MASTER - DISABLE (or ENABLE)

•SAVE CHANGES? - YES (or NO)

In the list above, factory settings are in italics, and factory defaults are in bold italics.

Command Line

The following list is a summary of the F131 commands:

Request a summary of all PTP settings:

F131 B<N>

>F131 B4

ERROR: INVALID COMMAND!

1. Only displayed when PTP CLOCK CONFIG, BAY # is SLAVE PRI/SEC/STBY

XLi IEEE 1588 Clock 123

997-01510-03, Rev. C, 12/12/2006