TechniSat DIGITY CI Operating Manual manual Switching DiSEqC on and off, Menu LNB Settings

bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 13

>Confirm by pressing OK. The menu LNB Settings will be displayed. (Fig. 5-8)

The following settings can be effected in this sub-menu:

5.4.1 Switching DiSEqC on and off

DiSEqC (Digital Satelliten Equipment Control) is a digital switching signal used to control DiSEqC-compatible components via the antenna connection.

If your external unit is equipped with DiSEqC componen ts you must activate the DiSEqC switching:

>In this line, use the OK key to switch the DiSEqC on or off.

As only one LNB can be controlled when the DiSEqC switching is not activated, the menu will be restricted to the configuration of a single LNB.

5.4.2Setting the switching matrix and the LNB characteristics

The menu lists the four switching criteria of the DiSEqC switching feature.

Your unit is pre-programmed so that ASTRA will be received in switch position A/A and Eutelsat will be received on switch position B/A of a multi-switch. Should the switching matrix of your receiving installation be configured differently, or if you wish to receive other satellites, you can adjust your receiver to the parameters of your receiving installation as follows.

>Use the arrow keys up/down to select the DiSEqC switch position (1-4) to which you wish to assign a satellite, by marking this line in blue (e.g.. A/B 3 No Satellite).

>Press OK.

A table showing the satellites available for selection will be displayed.

>Use the arrow keys up/down to mark the required satellite.

Use the arrow keys up/down to move up or down the menu one line at a time, use the arrow keys left/right to move forward or back one page at a time.

Should the satellite you require not be listed, please select one of the reserve slots, designated User1 to

User 14.

>Confirm by pressing OK. The selected satellite will now be inserted at the previously marked poosition in

the menu LNB Settings.

You should now proceed to work through the menu LNB Settings, until the settings in this menu correspond with the characteristics of your receiving installation. In the case of any switching criteria you do not require, select the option No Satellite.

Example:

A B

Position

Output

A B

Option

Output

(Fig. 5-8)

A B

Position

Output

13