bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 21
6.12 Timer
Your receiver is equipped with a timer. This allows you to make video recordings even when you are away. The timer mode is indicated by a blinking control LED in the display. Timer mode can be cancelled by pressing the On/Standby key.
6.12.1 Programming via EPG:
>Switch to the programme on which the item to be recorded is broadcast.
>Press the EPG key. The EPG table of the programme selected will be displayed.
>Use the arrow keys up/down to mark the required programme.
>Press the yellow function key (Record).
The data relating to the marked programme will now be stored in the timer memory, and will be displayed on screen for control purposes. (Fig.
>To delete a marked timer, press the green function key (Delete) and confirm when asked to do so on screen.
>Press the Back key to return to the EPG table, and, if you wish, to programme additional timer events
or
>Press the TV/Radio key to return to normal
operation.
The receiver will now select the appropriate programme at the programmed time, and will, if instructed to do so, revert to
6.12.2Manual programming/Changing timer set- tings
In addition to EPG timer programming you can also carry out manual programming of the timer. To do this, proceed as follows:
>Press the Menu key to display the Main Menu.
>Mark the item Timer and confirm by pressing OK. The Timer menu will be displayed. (Fig.
>Press the yellow function key (New) to go to timer programming, in order to programme a new timer event. (Fig.
>To alter an existing timer setting, mark this by using the arrow keys up/down. Press the yellow function key (Change) to access the settings of the marked
timer.
For programming, proceed as follows:
Source
>Use the arrow keys to mark the item Source, then use the OK key to enter the required source (TV or
Radio).
(Fig.
(Fig.
(Fig.
21
