Introduction

Table 1- 6: Certifications and Compliances (cont.)

FCC Compliance

Emissions comply with FCC Code of Federal Regulations 47, Part 15, Subpart B, Class A Limits

 

 

Installation (Overvoltage)

Terminals on this product may have different installation (overvoltage) category designations. The

Category

installation categories are:

 

 

CAT III Distribution-level mains (usually permanently connected). Equipment at this level is

 

 

typically in a fixed industrial location.

 

CAT II Local-level mains (wall sockets). Equipment at this level includes appliances, portable

 

 

tools, and similar products. Equipment is usually cord-connected.

 

CAT I

Secondary (signal level) or battery operated circuits of electronic equipment.

 

 

Pollution Degree

A measure of the contaminates that could occur in the environment around and within a product.

 

Typically the internal environment inside a product is considered to be the same as the external.

 

Products should be used only in the environment for which they are rated.

 

Pollution Degree 1

No pollution or only dry, nonconductive pollution occurs. Products in

 

 

 

this category are generally encapsulated, hermetically sealed, or

 

 

 

located in clean rooms.

 

Pollution Degree 2

Normally only dry, nonconductive pollution occurs. Occasionally a

 

 

 

temporary conductivity that is caused by condensation must be

 

 

 

expected. This location is a typical office/home environment.

 

 

 

Temporary condensation occurs only when the product is out of

 

 

 

service.

 

Pollution Degree 3

Conductive pollution, or dry, nonconductive pollution that becomes

 

 

 

conductive due to condensation. These are sheltered locations where

 

 

 

neither temperature nor humidity is controlled. The area is protected

 

 

 

from direct sunshine, rain, or direct wind.

 

Pollution Degree 4

Pollution that generates persistent conductivity through conductive

 

 

 

dust, rain, or snow. Typical outdoor locations.

 

 

 

 

Safety Standards

 

 

 

 

 

 

 

U.S. Nationally Recognized

UL1244

 

Standard for electrical and electronic measuring and test equipment.

Testing Laboratory Listing

 

 

 

 

 

 

Canadian Certification

CAN/CSA C22.2 No. 231

CSA safety requirements for electrical and electronic measuring and

 

 

 

test equipment.

 

 

European Union Compliance

Low Voltage Directive 73/23/EEC, amended by 93/69/EEC

 

EN 61010-1

Safety requirements for electrical equipment for measurement,

 

 

 

control, and laboratory use.

 

 

 

Additional Compliance

IEC61010-1

Safety requirements for electrical equipment for measurement,

 

 

 

control, and laboratory use.

 

 

 

 

1705A Spectrum Monitor

1- 7

Page 26
Image 26
Tektronix 1705A instruction manual Introduction Certifications and Compliances, Cat