Device View

When the network settings have been changed and set and Close is selected, the following dialog is displayed:

For the network settings to take effect, select OK to restart the device. Select Cancel if a restart is not required. The new settings will not take effect until the unit is restarted.

If necessary, obtain the IP Address, Gateway and Subnet Mask values from the

Network Administrator.

NOTE. If the Network Settings are changed and the MTM400 is restarted, the PC that is running the RUI will be unable to communicate with the MTM400, since the browser is trying to communicate with the previous network identity. It will be necessary to close the RUI by closing the Internet Explorer. Internet Explorer can then be reopened and the MTM400 accessed using the new network identity.

This is true of any WebMSM system configuration, which must be revised using the

WebMSM Configuration Editor (refer to the WebMSM user manual).

3-8

MTM400 MPEG Transport Stream Monitor User Manual