Tektronix Phaser 360 user manual Choosing a printer location, Removing the packing material

Getting Set Up 2

Choosing a printer location

To ensure proper printer operation:

1.Install the printer on a ßat surface. The degree of tilt should be no more than 3 degrees, approximately equivalent to lifting one side of the printer 2 cm (0.75 in.) off a ßat surface.

2.Allow at least 5 cm (2 in.) clearance on each side of the printer for proper ventilation and to prevent the printer from overheating.

Caution Some of the printer’s internal parts may be damaged or the printer may not operate properly if the printer isn’t adequately ventilated. Avoid leaving loose paper or packing materials next to the vent on the right side of the printer; they may adhere to the vent, causing the printer to overheat.

Removing the packing material

Remove the plastic bag and packing materials surrounding the printer.

Note Save all boxes and packing material in case you need to ship the printer later.

Registering the printer

Your product registration card is contained in the Register Now! envelope that is shipped with your printer. Fill out the appropriate card (U.S. or international versions) and mail it. By registering your printer with Tektronix, you validate the product warranty and ensure that you will receive information about upgrades, service, and accessories. You can also register on-line at the Tektronix web site:

http://www.tek.com./Color_Printers/

User Manual 2-3