Teledyne 200AU instruction manual Internal Variables, List

Teledyne API Model 200AU NOX Analyzer Instruction Manual, 02293, Rev. F

All of the default Data Channels sample more than one parameter, for these channels, each parameter is printed on a separate line.

There is also a compact format. If this attribute is enabled, all 3 concentration parameters are printed on one line as shown below:

D 94:08:00 0200 CONC : 120.0 100.0 20.0

The parameters are in the order of NOx, NO, and NO2.

To change any of the attributes of a particular data channel, the channel attributes are edited from the front panel by pressing the EDIT key.

5.5.8 Internal Variables

A list of M200AU variables is shown in Table 9-5.

A list of variables and their settings can be requested over the RS-232 port by:

V LIST Lists internal variables and values

The output from this command is long and will not be shown here. The general format of the output is:

name = value warning_lo warning_hi (data_lo to data_hi)

Where:
name	= name of the variable
value	= current value of variable
warning_lo	= lower limit warning (displayed if applicable)
warning_hi	= upper limit warning (displayed if applicable)
data_lo	= lower limit of allowable values
data_hi	= upper limit of allowable values

5-39