Thermador PDR36, PRG48, PRG30, PRG36, PDR30, PDR48 manual Emerson Appliance Controls

EMERSON APPLIANCE CONTROLS	DOCUMENT:	92S21720100
DIVISION OF EMERSON ELECTRIC CO.	REVISION: B
Product Specification for Sago Oven Control	PAGE:

13. DIAGNOSTIC CODES		DeBounce is the Rate at which the error checking occurs
	13.1	Diagnostic Code Checking
		The following chart describes the Fault code structure for the Control.
		Alarm fault monitor is always active. Any oven cancel key will reset
		the display to TOD idle.
CODE	DESCRIPTION	WHEN CHECKED	DEBOUNCE	ERROR	ACTION
				MESSAGE	TAKEN BY
				DISPLAYED	CONTROL
F13	Upper oven RTD not calibrated	Always	10 seconds	Message 1	Cancel
					cooking/timing
					functions
F14	Display board EEPROM error	Oven Programming	5 tries	Message 1	Cancel
					cooking/timing
					functions
F19	Power board Communication error	Always	20 seconds	Message 1	Cancel
					cooking/timing
					functions
F23	Keyboard gain unstable	Always	20 seconds	Message 1	Cancel
	Keyboard scratches				cooking/timing
	Loose molex or pins, air pocket in				functions
	control
F24	Keyboard disconnected	Always	20 seconds	Message 1	Cancel
					cooking/timing
					functions
F25	Keys stuck	Always	20 seconds	Message 1	Cancel
					cooking/timing
					functions
F26	Keys moving/dropping out	Always	20 seconds	Message 1	Cancel
					cooking/timing
					functions
F30	Upper oven sensor shorted	Always	20 seconds	Message 1	Cancel
					cooking/timing
					functions
F31	Upper oven sensor open	Always	20 seconds	Message 1	Cancel
					cooking/timing
					functions
F32	Upper oven over temperature while	Cleaning	20 seconds	Message 1	Cancel
	cleaning				cooking/timing
					functions
F33	Upper oven over temperature while	Non-Clean	20 seconds	Message 1	Cancel