Thermador PDR36 WTA 35 & WTL 54 Fault Codes & Troubleshooting, Anti, Time fault, Pump failed

B

WTA 35 & WTL 54 Fault Codes & Troubleshooting

Anti –	Time fault	Control module failed.	Check voltage at and wiring to
Crease/End	(drying time too		module. Turn off dryer, and
Light flashes	long)		replace faulty module.
		Door lock failed.	Check voltage at and wiring to
			door lock. Turn off dryer,
			measure door lock resistance and
			replace faulty door lock.
		Moisture sensor(s)	Run moisture sensor conductance
		failed.	test. Check voltage at and wiring
			to sensors. Turn off dryer and
			replace faulty sensor(s).
		Water level switch	Check voltage at and wiring to
		failed (WTL 5400	Hi-Limit. Turn off dryer, measure
		only).	Hi-Limit resistance and replace
			faulty Hi-Limit.
			Check voltage at and wiring to
		Hi-Limit (“overheat”)	Hi-Limit. Turn off dryer, measure
		thermostat tripped and	Hi-Limit resistance and replace
		failed to reset.	faulty Hi-Limit.
			NOTE: Hi-Limit trips @ 248°F
			(WTL 54) or 212°F (WTA 35)
			Have customer upgrade power
		Supply voltage too low.	system to provide consistent
			voltage to dryer during heating
			(need min. 198V).
E1	Pump failed	Pump failed.	Check voltage at and wiring to
	(WTL 5400		pump. Turn off dryer, measure
	condensation dryer		pump resistance (110 – 136 Ω)
	only)		and replace faulty pump.
---	Dryer won’t run	Dryer not turned on.	Turn “on/off” switch on.
	or indicator lights	No power to dryer	Check customer circuit breaker,
	won’t come on		fuse box or power connections.
	(no power to	Dryer fuse has blown.	Unscrew holder cap & replace
	dryer)		fuse (15A, type SC-15).

48