Thermador PRG30, PRG48, PRG36, PDR30, PDR36, PDR48 manual Gaggenau

GAGGENAU

Steamer VK 230

8 FUNCTION CODES

Faults at the appliance, a correct or incorrect adjustment as well as the RESET-function are indicated / confirmed by signals or error codes.

Explanations:

OOOFactory- / universal comparison successfully finished

FError during the RESET (internal self test)

F	1	Error when starting an adjustment, e.g. appliance
		has not yet been adjusted by a factory or universal
		comparison
		Or
		After starting the adjustment, the position „steaming“
		has not been chosen within 8 sec.
		Or
		After an adjustment another adjustment is started
F	2	Fault at the water sensor
F	3	Fault at the steam sensor

F4 Fault at the TRIAC or heating element or the water temperature has not increased for min 50°K/90°F

F 5 Water sensor not in right position (Function code

shown only possible during factory or universal comparison!)

F 6	Steam sensor faulty installed (only possible during
	factory or universal comparison!)
FAC	Factory comparison is running
dEF	Universal comparison is running
	Blinking heat up symbol
	Customer Comparison in use
	Blinking in the display
	Holyday safety function/after 4 h continuously
	running Reset: switch off/on appliance
	Drain symbol
	Drain valve did not reach end position
	Drain symbol
	Drain valve open
	Limiter symbol
	Dry run or overheating / above 107 °C/225°F
	If appliance will be switched off and on F 2 occurs in
	the display=Appliance /Sensor too hot.
	Reset: Switch off appliance to cool down

Display compl. Switched ON and sounding signal

Reset confirmation/Display and Buzzer check

Comparison now required

Blinking „o“

Child lock function in use

27