Thermador PRG36, PRG48, PRG30 SHX33, N/A, Service Tips – Fault Codes, SHV46C, SHX43E/46A-B,SL84A

B

Service Tips – Fault Codes (2)

DISHWASHER TEST PROGRAM ERROR CODES (on SHX33A/43E/46A-B, SHV46C, SL84A models):

●○○ – Heating system fault (heater, Hi-Limit, flow switch, control heater relay) ○●○ – NTC (temperature sensor) fault

○●● – Water filling fault
●○○ – N/A
	SHV46C, SHX43E/46A-B, SL84A
●○● – N/A
●●○ – Aqua sensor (sensotronic) fault		SHX33
●●● – N/A

TIP: Fault codes do NOT add up for multiple faults – shows highest fault code on list above (1st – heating, 2nd – NTC, 3rd – water filling, 4th – aqua sensor)

Fault code LED’s

Top Power Reg. Del./ Rinse Rack Scrub Wash Econo & Hold

Power	Reg.	Rinse
Scrub	Wash	& Hold

DISHWASHER TEST PROGRAM ERROR CODES (on SHU43E/53E/66E models):

							NOTE:	Flow
	Fa ults	LED Fault Codes				LED flashes	through heaters heat
							water ~ 2°F/minute.
		READY	CYCLE	CLEAN	NSF	LED lit
0	- No faults
						LED off
							HINT: Open door to select test
		READY	CYCLE	CLEAN	NSF
1	- Heater Element						program for fully-integrated models,
2	- Water Filling	READY	CYCLE	CLEAN	NSF		then close door to run program.
3	- NT C	READY	CYCLE	CLEAN	NSF	HINT: Dishwasher test program heat water to
						150°F, so test programs will generally run > 20
4	- Aquasensor	READY	CYCLE	CLEAN	NSF	minutes for incoming water temperatures ~120°F.