Toshiba B-EX4T1 manual Loading the Ribbon Cont, Auto Ribbon Saving Mode

2. PRINTER SETUP

ENGLISH VERSION EO1-33089

2.3 Loading Supplies

2.3.2Loading the Ribbon (Cont.)

3.Slide the Ribbon Stoppers along the Ribbon Shafts to a position where the ribbon is centred when fitted.

4.Lower the Print Head Block and set the Ribbon Shaft Holder Plate aligning its holes with the Ribbon Shafts.

5.Take up any slack in the ribbon. Wind the leading tape onto the ribbon take-up roll until the ink ribbon can be seen from the front of the printer.

Ribbon Shaft

Holder Plate

6.Turn the Head Lever to Lock position to close the Print Head.

7.Close the Top Cover.

Auto Ribbon Saving Mode

When the optional Ribbon Saving Module (B-EX904-R-QM-R) is installed, it is possible to reduce ribbon loss by stopping the ribbon feed for non-print areas. To activate the ribbon save, at least the following non-print area is required:

203 dpi mode						(mm)
	Print speed	3 ips	6 ips	10 ips	12 ips	14 ips
	Min. non-print area	20	20	35	60	75
305 dpi model							(mm)
	Print speed	3 ips	5 ips	8 ips	10 ips	12 ips	14 ips
	Min. non-print area	20	20	25	35	60	75

E2-11