Toshiba B-EX4T1 manual Parameter Setting Cont

2. PRINTER SETUP

ENGLISH VERSION EO1-33089

2.6 Printer Setting

2.6.2Parameter Setting (Cont.)

NOTE:

The print head may not be raised depending on the rise of the solenoid’s temperature.

NOTE:

1.Do not enable the ribbon saving function when the ribbon saving module is not installed. Doing so causes ribbon slack and print failure.

2.The ribbon saving option must be selected according to the head lever position. Incorrect setting may disable the proper ribbon saving function.

NOTE:

Pre-strip function is automatically enabled when the print speed is set to 10 ips.

(5) HU CUT/RWD.

This parameter is to choose whether or not to activate the head up action in the cut issue or to use the Rewinder in the batch or strip issue. This function prevents ribbon smudges by raising the print head during a reverse feed to the print start position.

•	OFF	Head up cut is not performed or the Rewinder is not
		used.
•	ON	Head up cut is performed or the Rewinder is used.

(6) RBN SAVE

This parameter is to choose whether or not to activate the ribbon saving function. This function enables reducing the ribbon loss caused by taking up unused ribbon during non-print areas.

•	TAG	Enabled (When the head lever is set to TAG
		position.)
•	LABEL	Enabled (When the head lever is set to Label
		position)
•	OFF	Disabled.

(7) PRE PEEL OFF

This parameter is to choose whether to activate the pre-strip function. When this parameter is set to ON, the top edge of a label is separated (pre-stripped) from the backing paper before the label is printed. This function is intended to make the strip issue easier in the case the labels are hard to strip due to the label intensity, adhesive power, or the printing speed.

•	OFF	Disables pre peel off
•	ON	Enables pre peel off

(8) BACK SPEED

This parameter is to choose a back feed speed.

In the strip issue, the back feed sped of 3 ips may cause a shortage of feed amount due to a lack of torque, slippery media surface, etc. In such case, reduce the back feed speed to 2 ips to secure the feed amount.

• STD	3ips
• LOW	2ips

E2-18