Toshiba B-EX4T1 manual Copying Data to/from USB Memory

2. PRINTER SETUP

ENGLISH VERSION EO1-33089

2.6 Printer Setting

2.6.12Copying Data to/from USB Memory

SYSTEM MODE

<10>RFID

<11>RTC

<12>Z-MODE

<13>USB MEMORY

The USB Memory menu allows copying data from a USB memory to the printer and saving data from the printer to a USB memory.

USB memory can be used only when an optional RTC & USB Host Interface Card, B-EX700-RTC-QM-R, is installed.

(1) USB TO PRINTER

This parameter is to copy data from a USB memory to the printer.

•	COPIED DATA	Data including firmware (BOOT/MAIN/
		CG/KANJI/HTML), storage area information,
		and parameter settings
•	CONFIG FILE	File containing firmware (BOOT/MAIN/
		CG/KANJI/HTML)

1.When the file selection screen is displayed, choose a file to be copied.

2.The confirmation message is displayed.

3.The data is read from the USB memory. It takes 3 to 5 minutes to read all information.

(2) PRINTER TO USB

This parameter is to save the firmware (BOOT/MAIN/CG/ KANJI/HTML), storage area information, and parameter settings to a USB memory.

NOTE:

If a file with the same name already exists in the USB memory, it will be overwritten.

•ALL

1.The confirmation message is displayed.

2.The data is copied to the USB memory. It takes approx. 40 seconds to save all information.

A file is automatically created in the USB memory and named in the following format based on the printer model and saved date.

/ATA0/SYSTEM/B-EX4T1-T1105.DAT

(e.g. B-EX4T Type1, 305 dpi model, November 5)

E2-39