Toshiba B-EX4T1 Parameter Setting Cont, This parameter is to choose a Maxicode specification

2. PRINTER SETUP

ENGLISH VERSION EO1-33089

2.6 Printer Setting

2.6.2Parameter Setting (Cont.)

(11) WEB PRINTER

This parameter is to choose whether to use the printer as a web printer. When the web printer is enabled, the status of the printer connected to a network can be monitored through the web browser.

NOTE:

Since a detected remaining ribbon length has some margin of error, use the specified length as a guide.

NOTE:

The type specified by the command may differ from the actual mode, depending on the status of this parameter. Also, the data transmission method differs partly.

For details, refer to the External Equipment Interface Specification.

•	OFF	Disables web printer function
•	ON INTERNAL	Enables web printer function (using an internal
		memory)
•	ON EXTERNAL	Enables web printer function (using an external
		memory)

(12) RBN NEAR END

This parameter is to choose the remaining ribbon length where the ribbon near end is detected.

•	OFF	Ribbon near end is not detected.
•	30m	Ribbon near end is detected when the remaining
		ribbon is 30-m long. (Equivalent to ribbon diameter
		of 38 mm)
•	70m	Ribbon near end is detected when the remaining

ribbon is 70-m long. (Equivalent to ribbon diameter of 43 mm)

(13) EX.I/O

This parameter is to choose a type of the expansion I/O interface operating mode. This parameter needs to be set depending on the expansion I/O control specification of the device to be connected via the expansion I/O interface.

•	TYPE1	Standard mode
•	TYPE2	In-line mode

(14) LBL/RBN END

This parameter is to choose a printer processing when a label end or ribbon end is detected.

•	TYPE1	When a label/ribbon end is detected in the middle of
		printing, the printer immediately stops printing.
•	TYPE2	Selectable only when the ribbon saving function is
		not activated.
		When a label/ribbon end is detected in the middle of
		printing, the printer prints the half-finished label as
		far as possible, and stops when the next label is at the
		home position.

(15) MAXI CODE

This parameter is to choose a Maxicode specification.

•	TYPE1	Compatible with the current version
•	TYPE2	Special specification

E2-21