Toshiba B-EX4T1 Position and Print Tone Fine Adjustment, Printer Setup, Fine adjustment ⇒Section

2. PRINTER SETUP

ENGLISH VERSION EO1-33089

2.9 Position and Print Tone Fine Adjustment

2.9Position and Print Tone Fine Adjustment

This section describes how to fine adjust a print start position, cut/strip position, reverse feed amount, print tone, and ribbon motor torque.

When a fine adjustment is required, follow the procedure below.

	Power ON
Power OFF		ONLINE Mode
			[PAUSE]

PAUSE state

Hold down [RESTART]

User System Mode

Hold down [MODE]

•Reset

•Parameter setting (⇒Section 2.6.2)

•Fine adjustment (⇒Section 2.9)

•LAN/WLAN (⇒Section 2.6.3)

•BASIC (⇒Section 2.6.4)

•Z-MODE (⇒Section 2.6.5)

•AUTO calibration (⇒Section 2.6.6)

•Dump mode (⇒Section 2.6.7)

•Log (⇒Section 2.6.8)

2.9.1 Fine Adjustment

USER SYSTEM MODE <1>RESET

<2>PARAMETER SET

<3>ADJUST SET

<4>LAN/WLAN

Contents of the Fine Adjustment Menu

Menu	Parameter
Adjust set	FEED ADJ.	Adjusts the feed amount to the
		print start position
	CUT ADJ.	Adjusts the cut or strip position.
	BACK ADJ.	Adjusts the reverse feed amount.
	X ADJUST	Adjusts the print position in X
		coordinate (horizontal direction)
	TONE ADJ. (TRANS.)	Adjusts the print tone for thermal
		transfer printing.
	TONE ADJ. (DIRECT)	Adjusts the print tone for direct
		thermal printing.
	RBN ADJ. <FW>	Adjusts the ribbon take-up motor
		drive voltage.
	RBN ADJ. <BK>	Adjusts the ribbon feed motor
		drive voltage.
	THRESHOLD <REFL.>	Sets a fine adjustment value for the
		threshold for the reflective sensor.
	THRESHOLD <TRANS.>	Sets a fine adjustment value for the
		threshold for the transmissive
		sensor.

NOTE:

The printer driver’s properties screen also has Parameter Fine Adjustment menu.

E2-60