Toshiba B-EX4T1 manual Threshold Setting Cont, Press the RIGHT to see the details, e.g Succeeded

2.PRINTER SETUP

ENGLISH VERSION EO1-33089

2.10 Threshold Setting

2.10Threshold Setting (Cont.)

NOTE:

To make a threshold value set in this section effective, select the Transmissive Sensor (when using pre-printed media) or Reflective Sensor (when using manual threshold value) in Issue Command or the printer driver.

	Display example	Explanation
1		Result: OK (Mid.)
		Threshold is at the midpoint between the
		peak and the baseline.
2		Result: OK (High)
		Threshold is near the peak voltage.
		Adjusting the threshold to the midpoint
		between the peak and the baseline enables
		more accurate detection.
3		Result: OK (Low)
		Threshold is near the baseline voltage.
		Adjusting the threshold to the midpoint
		between the peak and the baseline enables
		more accurate detection.
4		Failed (1)
		The media sensor cannot detect a gap/black
		mark. Sensor adjustment is required.
		(⇒Section 2.11)
5		Failed (1)
		The media sensor cannot detect a gap/black
		mark. (Threshold ≤ Baseline) Sensor
		adjustment is required. (⇒Section 2.11)
6		Failed (2)
		Detection by the media sensor is disabled.
		Sensor adjustment is required. (⇒Section
		2.11)

(5) Press the [RIGHT] to see the details.

(e.g: Succeeded) (e.g.: Failed)

Sensor type Peak voltage Threshold voltage Baseline voltage Key operation guide

NOTE:

The threshold can be manually set as follows:

Manually set threshold = Peak voltage – Threshold fine adjustment value

e.g.) When Peak=3.5V and Fine adjustment value=1.0V, the threshold will be set to 2.5V.

(6)To return to the previous display, press the [LEFT].

To adjust the threshold, press the [RIGHT]. The threshold fine adjustment screen in ADJUST SET menu appears.

Set a value and press the [ENTER].

(7)The result after manually setting the threshold is displayed.

E2-68