Toshiba B-SX600 manual Standard model, Remarks

13. FREQUENTLY ASKED QUESTIONS (FAQ)

Q: Are there any limitations on a print or feed speed in Strip mode?

A:

When the model with the Peel-off Unit is used, a print speed needs to be reduced to 4 ips or less to ensure the steady peel-off operation. (In the printer driver, a feed speed is set to the same value as a print speed.)

A print speed needs to be further reduced to 2 or 3 ips depending on the type or size of the media. Check the peel-off operation first, then adjust a print speed if necessary.

Q:Is there any difference in acceptable media and ribbons between the standard model and the model with the Peel-off Unit?

A:

There is no difference between the standard model and the model with the Peel-off Unit in the material of the acceptable media and ribbons. However, when performing peel-off operation, the size of the available media is different.

	Standard model		Model with Peel-off Unit	Remarks
Max. backing paper		120 mm
width
Min. label length	5 mm		12 mm
Min. media width	15 mm		10 mm
Fanfold paper	Allowed		Not allowed	Media may be torn off
Perforation				from perforation.
Min. label thickness	0.05 mm		0.05 mm
Max. thickness of	0.1 mm		0.1 mm	Glassine paper
backing paper
Roll direction	Inside/outside		Inside

In addition to the above specifications, be careful of the following points when using the model with the Peel-off Unit.

The acceptable media length for the Peel-off Unit is the same as that of the standard model. However, when using a long label, prevent a peeled one from sticking to the table on which the printer is placed.

Do not use a media roll with seams. Use a label stock with seamless backing paper.

Neither fabrics nor special labels are usable. Also, using non-rectangular labels is not allowed.

13- 5