Toshiba e-STUDIO2500c/3500c/3510c manual Energy Saving Mode

1 BEFORE USING EQUIPMENT

3 “Processing job will be deleted. Are you sure you want to shut- down?” appears on the menu. Press the [YES] button.

To cancel the shutdown operation, press the [NO] button.

4 “Shutdown in progress” appears on the menu. After a while, the equipment is shut down and the power is turned OFF.

The power switch automatically returns to the OFF position.

Energy Saving Mode

This equipment supports two energy saving modes; the Automatic Energy Save mode and the Sleep Mode.

Automatic Energy Save

The equipment enters the Automatic Energy Save mode automatically after a specified period of time*1 since its last use. During this mode, “Saving energy – Press START button” appears on the touch panel.

Sleep Mode

The equipment enters the Sleep Mode automatically after a specified period of time*2 since its last use. During this mode, the message of the Automatic Energy Save mode disappears and the [ENERGY SAVER / SHUTDOWN] button lights in green.

These modes are automatically cleared upon the reception of print data, Fax data, Internet Fax data or E-mails. They are also cleared by pressing the [START] button.

Note 1: This period is set at 15 minutes by factory default.

Note 2: This period is set at 60 minutes for the e-STUDIO2500c/3500c and 90 minutes for the e- STUDIO3510c by factory default.

Contact your service representative to change the default settings noted above.

52 Preparation 2- Turning power off (Shutdown)