Toshiba EO1-33057D, B-SX8T SERIES owner manual Removing Jammed Media Cont

5. TROUBLESHOOTING

ENGLISH VERSION EO1-33057

5.3 Removing Jammed Media

5.3Removing Jammed Media (Cont.)

8.Release the Media Sensor Harness from the last Cable Clamp attached at the end of the Media Sensor Plate. Then, remove the Media Guide Plate from the printer.

NOTE:

When re-installing the Media Guide Plate, insert the Movable Media Sensor into the portion A of the Media Guide Plate.

Movable Media Sensor

Portion A

	Cable Clamp
	Media Guide
Media Sensor
	Plate
Harness

9.Remove jammed media from the media path. DO NOT USE any sharp implements or tools as these could damage the printer

Media Path

10.Clean the Print Head and Platen, then remove any further dust or foreign substances.

11.Clean the Media Guides (Refer to Section 4.1.3)

12.Paper jams in the Cutter Unit can be caused by wear or residual glue from label stock on the cutter. Do not use non-specified media in the cutter.

13.Re-install the Media Guide Plate on the printer in the reverse order of removal. At this time do not forget to fasten the Media Sensor Harness by the Cable Clamps.

When fastening the harness by the centre Cable Clamp, place the blue and green harnesses over the yellow harness, and remove the slack of the harnesses, as shown in the picture below.

Harness (Yellow)

Harness (Blue) Harness (Green)

Media Guide Plate

E5- 6