Toshiba B-SX8T SERIES, EO1-33057D owner manual Installation, Assembling the Supply Holder Frame

2. PRINTER SETUP

ENGLISH VERSION EO1-33057

2.1 Installation

2.1 Installation

2.2.Assembling the Supply Holder Frame

To insure the best operating environment, and to assure the safety of the operator and the equipment, please observe the following precautions.

•Operate the printer on a stable, level, operating surface in a location free from excessive humidity, high temperature, dust, vibration or direct sunlight.

•Keep your work environment static free. Static discharge can cause damage to delicate internal components.

•Make sure that the printer is connected to a clean source of AC Power and that no other high voltage devices that may cause line noise interference are connected to the same mains.

•Assure that the printer is connected to the AC mains with a three- prong power cable that has the proper ground (earth) connection.

1.Assemble the Supply Holder Frame (L) and Supply Holder Frame (R) to the Supply Holder Base using the two M-4X6 Wing Bolts supplied, as shown below.

.

	Wing Bolt	Supply Holder Frame (L)
Dowel			Supply Holder Base
	(M-4x6)

Supply Holder Frame (R)

2.Attach the assembled Supply Holder Frame to the rear of the printer by inserting the hooks of the Frame into the two slots in the rear of the printer, as shown below.

Slot Hook Printer

Supply Holder Frame

E2- 2