Toshiba EO1-33057, B-SX8T SERIES Parameter Setting Cont, Head Up Cut Selection, up to -5.0 mm

2. PRINTER SETUP

ENGLISH VERSION EO1-33057

2.8 Setting an Operating Environment

2.8.1Parameter Setting (Cont.)

When ON is selected, pressing the [PAUSE] key will result that the LCD Message Display shows the stop position fine adjustment value setting screen.

<2>PARAMETER SET POSITION +0.0mm

	POSITION +5.0mm
[RESTART]
	POSITION +0.0mm
[FEED]
	POSITION -5.0mm
[FEED] key:	Pressing the [FEED] key one time causes a –0.1mm change,

up to –5.0 mm.

[RESTART] key: Pressing the [RESTART] key one time causes a +0.1mm change, up to +5.0 mm.

NOTE:

The print head may not be raised depending on the rise of the solenoid’s temperature.

After selecting an auto forward wait, press the [PAUSE] key.

(10) Head Up Cut Selection

This parameter is to choose whether to activate the head up action in the cut issue.

This function prevents ribbon smudges by raising the print head during a reverse feed to the print start position.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET HEAD UP CUT OFF

Use the [FEED] or [RESTART] key to select a desired option.

				Activated
		HEAD UP CUT	ON
[RESTART]
	[FEED]	HEAD UP CUT	OFF	Not activated

After selecting the head up action in cut issue, press the [PAUSE] key.

E2-25