Toshiba EO1-33057D Parameter Setting Cont, Plug & Play Selection, Label End/Ribbon End Selection

2. PRINTER SETUP

ENGLISH VERSION EO1-33057

2.8 Setting an Operating Environment

2.8.1Parameter Setting (Cont.)

NOTE:

If the printer and the PC are connected by USB, plug & play will be automatically enabled, regardless of the setting of this parameter.

(24) Plug & Play Selection

This parameter is to choose whether to enable a Plug & Play function. When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET PLUG & PLAY OFF

Use the [FEED] or [RESTART] key to select a desired option.

			Unavailable
[RESTART]		PLUG & PLAY OFF
	[FEED]		Available
		PLUG & PLAY ON

After selecting a Plug & Play, press the [PAUSE] key.

(25) Label End/Ribbon End Selection

This parameter is to choose a printing process when a label end or ribbon end is detected.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET LBL/RBN END TYP1

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

LBL/RBN END TYP1

TYPE1: When a label/ribbon end is detected in the middle of printing, printing is immediately paused.

LBL/RBN END TYP2

TYPE2: When a label/ribbon end is detected in the middle of printing, the printer prints the half-finished label as far as possible, and stops when the next label is at the home position.

After selecting a Label End/Ribbon End type, press the [PAUSE] key.

E2-33