Toshiba B-SX8T SERIES, EO1-33057D APPENDIX 1 MESSAGES AND LEDS, Symbols in the message

APPENDIX 1 MESSAGES AND LEDS

ENGLISH VERSION EO1-33057

APPENDIX 1 MESSAGES AND LEDS

APPENDIX 1 MESSAGES AND LEDS

Appendix 1 describes the LCD messages displayed on the operation panel.

Symbols in the message

1:: The LED is illuminated. ~: The LED is flashing. z: The LED is unlit.

2:****: the number of unprinted media. Up to 9999 (in pieces)

3:###: Flash memory card remaining memory for PC save area: 0 to 3072 (in K bytes)

4:&&&&: Remaining flash memory capacity for storing writable characters 0 to 3072 (in K bytes)

			LED Indication				Restoration by	Acceptance of
No.	LCD Message					Printer Status	RESTART	Status Request
				ON				Reset Command
			POWER	LINE	ERROR		key Yes/No	Yes/No
1	ON LINE				z	Online mode	-----	Yes
	ON LINE			~	z	Online mode (communicating)	-----	Yes
2	HEAD OPEN			z	z	The print head or pinch roller is opened in	-----	Yes
						online mode.
3	PAUSE ****			z	z	Pause state	Yes	Yes
						A parity, overrun, or framing error has	Yes	Yes
4	COMMS ERROR			z		occurred during a communication by RS-
						232C.
5	PAPER JAM	****		z		A paper jam has occurred during paper	Yes	Yes
						feed.
6	CUTTER ERROR****			z		A problem has occurred at the cutter	Yes	Yes
						module.
7	NO PAPER	****		z		The media has run out, or the media is not	Yes	Yes
						loaded properly.
8	NO RIBBON	****		z		The ribbon has run out.	Yes	Yes
						A feed or an issue was attempted with the	Yes	Yes
9	HEAD OPEN	****		z		print head or pinch roller opened. (Except
						when the [FEED] key is pressed.)
10	HEAD ERROR			z		The print head has a problem.	Yes	Yes
11	EXCESS HEAD TEMP			z		The print head is overheated.	No	Yes
						The ribbon has been torn. A problem has	Yes	Yes
12	RIBBON ERROR****			z		occurred with the sensor that determines
						the torque for the ribbon motor.
13	SAVING ####&&&&				z	In writable character or PC command save	-----	Yes
						mode
14	FLASH WRITE ERR.			z		An error has occurred in writing to the	No	Yes
						flash ROM.
15	FORMAT ERROR			z		An error has occurred in formatting the	No	Yes
						flash ROM.
16	FLASH CARD FULL			z		Saving failed because of an insufficient	No	Yes
						capacity of the flash ROM.
17	Display of error			z		A command error has occurred in	Yes	Yes
	message (See Note.)					analyzing the command.
18	POWER FAILURE			z		A momentary power failure has occurred.	No	No
19	INTIALIZING…			z	z	The flash ROM is being initialised.	-----	-----
20	EEPROM ERROR			z		Data cannot be read from/written to a	-----	-----
						backup EEPROM properly.

EA1- 1